The washing machine constantly draws water

Few people today spend time washing by hand, because there are quite a lot of affordable washing machines. Therefore, when some kind of malfunction occurs, for example, a washing machine constantly draws water, but nothing else happens, many are puzzled, so what to do next? In fact, any problem with the washer requires a call from a master who has sufficient qualifications and experience to solve various problems with such units. If you decide first to figure out for yourself what the failure actually is and how much the repair of your equipment may cost, we suggest that you familiarize yourself with the reasons why the washing machine draws water but does not wash.

to contents ↑

Reason 1 - Incorrect connection

If the equipment is new and you use it for the first time, perhaps the reason is very commonplace - when connected, they neglected to level the machine or install a drain hose. As a result, the water goes into the sewer by gravity, the machine “thinks” that there is not enough water for washing and continues to add it. And further on the vicious circle.

Checking the fact of your own negligence or dishonesty of specialists is quite simple - check the location of the drain hose - it should be slightly above the tank.

If physically this is not possible, for example, a cabinet or a bath screen is closely located, proceed as follows:

1. Turn on the wash cycle.
2. Wait for the moment when the tank is filled with water.
3. Set the “drain” function.
4. Pause as the water decreases.

We evaluate the result:

• if the water in the machine continues to decrease in standby mode, the problem is in connecting the drain;
• if the water level does not change - be upset, the problem is that the washing machine is constantly collecting water, in an internal breakdown.

Trust the solution to the connection with a professional master. Be sure to check the result of his work. And if you decide to connect the device yourself, use the information from our post "Rules for installing a washing machine".

to contents ↑

Reason 2 - measuring and regulating devices do not work correctly

The pressure switch is a functional element of this type of household appliances. It is he who has the full responsibility for controlling the water level in the equipment. Therefore, if it is broken, it is strange to expect that the amount of water will be drawn in the right amount.

Important! Incorrect data can be sent to the unit's programmer, not only because of a breakdown of the sensor itself, but also because of clogging or scaling on the internal pressure elements that operate under the pressure of the water pressure.

To determine what the cause is in the pressure switch, do the following:

1. Disconnect the unit from the power supply.
2. Open the back cover.
3. Determine, using the instructions from the data sheet, the location of the sensor.
4. Inspect it for oxidized contacts.

We evaluate the result:

1. If there are any damaged contacts, clean them with suitable means.
2. If they are in satisfactory condition - call the master, you need to disassemble the equipment and look for the internal reason why the washing machine constantly draws water, but does not wash.

Important! If the contacts cannot be cleaned, a sensor replacement is also needed.

to contents ↑

Reason 3 - breakdown of valves

From shut-off and control valves, the reason that the washing machine draws a lot of water can only be the inlet valve. It is he who blocks the flow when such a command arrives from the control module.

If the connection loosens, the membrane in the valve is weakened, or the body material has cracked, respectively, it leaks or water becomes blocked. As a result, your washing machine continuously draws water.

Important! The solution to this problem is to tighten the mounting points or completely replace the valve. Performing the latter without appropriate experience is not recommended, so as not to aggravate the situation. Serious damage repairs should be entrusted to a service center specialist, especially if the washing machine is on warranty service.

to contents ↑

Stock footage

That's all. The reasons that the washing machine draws a lot of water are not so many and they are all listed. In almost any case, with a 90% probability, you will need the help of a qualified craftsman. Therefore, do not waste time in vain, but search for a suitable specialist.