The refrigerator runs for 5 seconds and turns off

For us, there is nothing new in the operation of the refrigerator when we hear periodic shutdowns / turns on. This is the specifics of the operation of the cooling system, in particular the compressor. The frequency of on / off depends on the mode in which it works (how much it freezes). But it’s absolutely abnormal that your household appliances turn off with a minimum period of time, namely, the refrigerator works for 5 seconds and turns off. If the engine often starts and shuts off, then during such work the temperature conditions will not be observed and the products may deteriorate. Accordingly, it is necessary to understand the causes of this phenomenon and troubleshoot. How to do this, you will learn from this article.

to contents ↑

What happens to your fridge?

There are many different reasons why the refrigerator works for 5 seconds, turns off and after a while completely stalls. First, check the mains voltage. Due to the voltage drop in the network, the compressor stops. If this was the problem, then we advise you to choose and put voltage regulator for the refrigerator. Modern smart refrigerators are most often cleaned from all sorts of incidents. But the list of problems why the Indesit refrigerator turns on for a few seconds and then turns off is versatile.

to contents ↑

How to determine the working period?

The concept is turned on / off purely individually. Maybe you think that there is a problem with the refrigerator, it does not turn on for a long time. In fact, this is the specifics of the work. Therefore, we suggest you use a formula that determines the ratio of the idle time to the refrigerator. You need to change uptime and downtime. Then the compressor on period.

Important! When the compressor works in the interval - 2 minutes it works 10 rests, we derive the formula 2 / (2 + 10) = 0.167, it is considered incorrect. The correct operating mode of the refrigerator should be with a coefficient ranging from 0.2-0.9.

So, if you calculated a coefficient that does not meet these standards, then there are some problems with its cooling system. And what can lead to this, we will consider below.

to contents ↑

Reasons for the malfunction

The reasons that the refrigerator works for 5 seconds and turns off may be different:

1. The compressor is out of order.
2. The starting relay burned out.
3. The problem with the electronic unit.
4. Low voltage.

to contents ↑

Diagnostic Methods

And a very important point is the correct diagnosis of damage. Correct diagnosis is the first step to troubleshooting. At the beginning of the repair, the simplest faults are checked. You need to follow the path of least resistance - from easy to complex.

Your tactics:

• Check the voltage in the network.
• Inspects the outlet; check the contacts.
• Check / ring the compressor.
• Inspect the relay.
• Check the electronic unit.

These are the main directions for checking the malfunction of your refrigerator.

It is very simple to determine the operation of the refrigerator by ear. You just need to listen to him. If the time interval for turning on the compressor is minimal, then there is a problem. This has a very negative effect on its shelf life. Replacing a compressor is expensive, and you may need to visit a service center.

Maybe a problem with relay, replace it. This is an inexpensive procedure, plus it does not require a lot of time and effort. During the examination, it may turn out that the control board is out of order. Replacing this device will require you to make small financial investments and possibly contact a specialist.

to contents ↑

Troubleshooting Methods

When fixing the breakdown, we will be guided by the rule that we are not professionals, but pioneers. It will most likely not be a repair of a malfunction, but a detailed clarification, by disassembly and the method of scientific poking.

So, we solve the problem that the refrigerator works for 5 seconds and turns off:

1. To check the compressor's performance, it is necessary to measure the resistance of its windings. It must correspond to the nominal value. Just take and check between each pair of terminals. If you understand that everything works, then you can calmly breathe out - everything is in order with the motor.
2. We turn to the study of relays. The malfunction of the relay controller can be determined by eye, using disassembly. The cause is determined immediately; failure is common. Take and replace with another relay. If the refrigerator began to work correctly, then you yourself have coped with the task. In some cases, when the core of the solenoid is destroyed, a wire is installed instead. But this is only in older models. Usually in modern refrigerators, the relay works so quietly that it cannot be heard when it switches. And no one pays attention to turning it off. They start to sound the alarm when the refrigerator stops working or works for 5 seconds and turns off.
3. If the problem of malfunction lies in the breakdown of the control board, you can limit yourself to a flashing. But this should be understood by a specialist. The board is the think tank and needs the right approach.
4. To check the voltage in the network, a special tester is needed - a multimeter or probe. Both that, and another, can help you. But nevertheless, a special tester with a display is better, which will show not only the absence of current in the network, but also its value. Everything is very simple: turn on the device for measuring AC voltage. For a household network, switch to the 750 Volt mark. As soon as three zeros are displayed on the board, insert two probes into the corresponding holes and measure the voltage.

to contents ↑

Stock footage

If you are well versed in the repair of household appliances, then this type of repair you will be able to do. But in general, of course, contacting a specialist will be the most correct decision. The masters will save you from the need to understand the wisdom and intricacies of the cooling system of the refrigerator yourself. Especially for such procedures, a suitable tool plus knowledge and skills should be available.